Re: WG6100 issue

Check the two big 10W resistors. It should be a non-inductive part.

-Scott

At 10:58 AM 4/13/2009, you wrote:
>I'm working on this WG6100 where some vectors (esp. on the letters)
>seem to be badly drawn.
>
>Check out this very short video:
>
>http://www.youtube.com/watch?v=_pmbmheq7Gg
>
>Note the W and the other letters don't look as nice as on my Amplifone.
>
>The PCB set is normally running in my cockpit and working fine on my
>25" Amplifone so it's not a PCB issue.
>The WG6100 has a LV2000 installed, cap-kit and redone all solderings
>on deflection and neck pcb.
>LV2000 voltages are exactly set at 26.00V and -26.00V
>As mentioned PCB set works fine, BIP is correctly set-up.
>
>Is this because of WG's lower slew-rate or can something be done to
>correct this ?
>
>Thanks.
>---------------------------------------------------------------------------
>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Apr 13 16:44:52 2009