Re: WG6100 issue

That is a brilliant hint, thanks !

Stupid from me as I've read about this before but thought it was
Amplifone only....

Gonna check it out. Anyway I can recognize if they're non-inductive or
not ?

Thanks !

Op 13 apr 2009, om 22:43 heeft Scott Swazey het volgende geschreven:

> Check the two big 10W resistors. It should be a non-inductive part.
>
> -Scott
>
> At 10:58 AM 4/13/2009, you wrote:
>> I'm working on this WG6100 where some vectors (esp. on the letters)
>> seem to be badly drawn.
>>
>> Check out this very short video:
>>
>> http://www.youtube.com/watch?v=_pmbmheq7Gg
>>
>> Note the W and the other letters don't look as nice as on my
>> Amplifone.
>>
>> The PCB set is normally running in my cockpit and working fine on my
>> 25" Amplifone so it's not a PCB issue.
>> The WG6100 has a LV2000 installed, cap-kit and redone all solderings
>> on deflection and neck pcb.
>> LV2000 voltages are exactly set at 26.00V and -26.00V
>> As mentioned PCB set works fine, BIP is correctly set-up.
>>
>> Is this because of WG's lower slew-rate or can something be done to
>> correct this ?
>>
>> Thanks.
>> ---------------------------------------------------------------------------
>> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>> ** Please direct other questions, comments, or problems to chris@westnet.com
>
> ---------------------------------------------------------------------------
> ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
> ** Please direct other questions, comments, or problems to chris@westnet.com

André Huijts
andre.huijts@upcmail.nl

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Apr 13 17:11:20 2009