Re: WG6100 issue

IIRC, Some of the parts were stamped "NI". Just read the part number off
the resistor and look it up on Google.

-Scott

At 02:11 PM 4/13/2009, Andre Huijts wrote:
>That is a brilliant hint, thanks !
>
>Stupid from me as I've read about this before but thought it was
>Amplifone only....
>
>Gonna check it out. Anyway I can recognize if they're non-inductive or
>not ?
>
>Thanks !
>
>Op 13 apr 2009, om 22:43 heeft Scott Swazey het volgende geschreven:
>
> > Check the two big 10W resistors. It should be a non-inductive part.
> >
> > -Scott
> >
> > At 10:58 AM 4/13/2009, you wrote:
> >> I'm working on this WG6100 where some vectors (esp. on the letters)
> >> seem to be badly drawn.
> >>
> >> Check out this very short video:
> >>
> >> http://www.youtube.com/watch?v=_pmbmheq7Gg
> >>
> >> Note the W and the other letters don't look as nice as on my
> >> Amplifone.
> >>
> >> The PCB set is normally running in my cockpit and working fine on my
> >> 25" Amplifone so it's not a PCB issue.
> >> The WG6100 has a LV2000 installed, cap-kit and redone all solderings
> >> on deflection and neck pcb.
> >> LV2000 voltages are exactly set at 26.00V and -26.00V
> >> As mentioned PCB set works fine, BIP is correctly set-up.
> >>
> >> Is this because of WG's lower slew-rate or can something be done to
> >> correct this ?
> >>
> >> Thanks.
> >>
> ---------------------------------------------------------------------------
> >> ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> >> ** Please direct other questions, comments, or problems to
> chris@westnet.com
> >
> > ---------------------------------------------------------------------------
> > ** Unsubscribe, subscribe, or view the archives at
> http://www.vectorlist.org
> > ** Please direct other questions, comments, or problems to
> chris@westnet.com
>
>André Huijts
>andre.huijts@upcmail.nl
>
>
>
>
>
>---------------------------------------------------------------------------
>** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
>** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Apr 13 17:23:59 2009