Rodger Boots wrote:
> There is a brightness control and a contrast control. Brightness sets
> the brightness of the darker lines and contrast sets the brightness of
> the brighter lines.
>
> If you set contrast to minimum, then set brightness so darker lines are
> visible, then set contrast for desired brightness of bright lines, you
> should be good.
Not on a Cinematronics monitor... the intensity of both hi and lo
brightness lines is set by a single brightness control, and the
difference between the line intensities is set by a resistor (I believe
it's R10 - can anybody confirm this?) The value of this resistor could
be changed for a different 'lo' brightness value (has anybody tried this?)
-Lewis
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Jun 1 11:01:22 2009
This archive was generated by hypermail 2.1.8 : Mon Jun 01 2009 - 12:50:00 EDT