Re: 13" Amplifone z / Blanking problem.

Hello Andrew,

Yes I have a pat900. the Pat is using a known good space duel. Have plugged
a 6100 in it to test the outputs, and the 6100 works fine. I have also
plugged the 13" into 3 known working machines. Tempest, Star Wars, and Space
duel. All display the same problem.

I've been working with Rodger on this last night, and there is definitely
something wrong with the blanking circuit, we just haven't been able to
determine what yet. The spot killer led is on all the time. The 13" is built
quite a bit different than a normal 19" so you can't go by the 19"
schematics.

It got late last night, so we never figured out what was causing the Spot
killer problem.

Kevin

On Mon, Jun 21, 2010 at 2:53 AM, Andrew Welburn <andy@andysarcade.net>wrote:

> Well, i think the fact that you see all three colours on at the same time
> and all the retrace lines is because you have no Z at all, AND you have the
> brightness up way too far...
>
> Without any Z's, you should have a blank screen, but you can make yourself
> feel better that the monitor is not completely dead by turning up the
> brightness where you'll see the XYpicture of sorts...
>
> So, i think you need to be looking at something that is common to the three
> 'Z' RGB circuits..
>
> Because you have an amplifone 13", i might be assuming (maybe wrongly) that
> you have a pat9000 there... can you absolutely confirm that you have 3 good
> RGB 'Z' channels coming from it and going into the monitor? or are you using
> something else to test it? scope the RGB Z to make sure.
>
> The PAT is about as reliable as any other old videogame, so make sure that
> you really do have RGB 'Z' going into your monitor in the first place.
>
> The fact that you can adjust the intensities of the individual guns makes
> it all sound liek you either have no RGB Z input, or something early on in
> the blanking stages is bad, but common to all three.
>
> --
> Andrew Welburn
> http://www.andys-arcade.com
>
> ----- Original Message -----
> *From:* Kevin Moore <talon.k@gmail.com>
> *To:* vectorlist@vectorlist.org
> *Sent:* Monday, June 21, 2010 3:00 AM
> *Subject:* VECTOR: 13" Amplifone z / Blanking problem.
>
> So I've been digging around for the past couple days with this Amplifone
> monitor with little luck.
>
> All the colors are on at the same time, and I'm getting retrace lines.
>
> I am able to adjust the colors intensity individually.
>
> I can adjust screen, and brightness.
>
> Looking at the schematics, it seem the blanking and Z control are one in
> the same? I'm still not 100% up on vector monitors.
>
> Basically what I have is white lines for everything, including the retrace
> lines.
>
> I've checked the RGB transistors on the neck board for possible shorting,
> causing all the guns to come on all the time, I've replaced all the
> transistors in the input protection circuit, and the spot killer circuit..
>
> I'm at a loss for the moment.
>
> Kevin
>
>

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Jun 21 09:40:29 2010