On Mon, 30 Aug 2010, Rodger Boots wrote:
>
> With signal removed from the scope adjust positions to put the dot in the
> center of the screen, then reconnect the signals and see if the picture is
> centered on the screen. BOTH INPUTS MUST BE IN DC MODE, NOT AC.
My guess from what he is describing would be a bad voltage regulator on
the game board. There are test points for all the voltages, I would just
check all the voltages to make sure they are correct.
==========================================================
Chris Candreva -- chris@westnet.com -- (914) 948-3162
WestNet Internet Services of Westchester
http://www.westnet.com/
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Mon Aug 30 10:59:46 2010
This archive was generated by hypermail 2.1.8 : Mon Aug 30 2010 - 11:50:01 EDT