Re: Can someone please confirm this is correct? Replacing MPSU07 and MPSU57

Not sure about this, if you haven’t tried it actually.
The MPSU07 and MPSU57 can handle higher frequencies much better
Their Voltage-Gain-Bandwidth-Product is 50Mhz min., while the TIP31C/32C have only 3Mhz min.

- Andreas

From: Rodger Boots
Sent: Thursday, February 07, 2013 7:38 PM
To: vectorlist@vectorlist.org
Subject: Re: VECTOR: Can someone please confirm this is correct? Replacing MPSU07 and MPSU57

Should work fine.

On Feb 7, 2013 12:34 PM, "Grant Thienemann" <grant.thienemann@gmail.com> wrote:

  Hey Guys,

  I'm working on a couple of amplifones and I I'm going to completely
  rebuild one from the ground up and I want to replace the MPSU07 and
  MPSU57.

  I'm looking at TIP31C and TIP32C to replace them, and I was going to
  use a model that can handle more voltage as well, specifically this
  one:

  http://www.digikey.com/product-detail/en/TIP31C/TIP31CFS-ND/458805

  Now MPSU07 has a E-B-C pint out and the TIP31C has a B-C-E pin out, I
  can just rearrange the pins to make this work correct?

  Same thing for the MPSU57, I'm looking to replace them with this:

  http://www.digikey.com/product-detail/en/TIP32C/TIP32CFS-ND/458807

  Please let me know if this is correct and if I can just shift the pins
  around to make it work!

  Thanks
  Grant
  ---------------------------------------------------------------------------
  ** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
  ** Please direct other questions, comments, or problems to chris@westnet.com

---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Feb 7 14:00:22 2013