Could be, remove the CPU and see if they are still low. That will tell you
if it is the CPU or the board.
On Oct 9, 2013 10:50 PM, "Joel Griffin Dodd" <griffindodd@gmail.com> wrote:
> Hey guys. Troubleshooting my non booting star wars board set.
>
> Checked all my voltages and clicks they look good.
> Firq, NMI and halt are all high
> However reset is permanently low as is Irq at the CPU.
>
> Any ideas where to go from here? Bad CPU?
>
> I'm following the star wars troubleshooting guide
>
> Joel
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Wed Oct 9 23:55:02 2013
This archive was generated by hypermail 2.1.8 : Thu Oct 10 2013 - 00:50:00 EDT