Yep both still low with CPU removed
On Oct 9, 2013 8:55 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
> Could be, remove the CPU and see if they are still low. That will tell
> you if it is the CPU or the board.
> On Oct 9, 2013 10:50 PM, "Joel Griffin Dodd" <griffindodd@gmail.com>
> wrote:
>
>> Hey guys. Troubleshooting my non booting star wars board set.
>>
>> Checked all my voltages and clicks they look good.
>> Firq, NMI and halt are all high
>> However reset is permanently low as is Irq at the CPU.
>>
>> Any ideas where to go from here? Bad CPU?
>>
>> I'm following the star wars troubleshooting guide
>>
>> Joel
>>
>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Oct 10 00:00:48 2013
This archive was generated by hypermail 2.1.8 : Thu Oct 10 2013 - 00:50:00 EDT