Start looking for where these come from and work your way back. You did
check for missing/broken crystal, right?
On Oct 9, 2013 11:00 PM, "Joel Griffin Dodd" <griffindodd@gmail.com> wrote:
> Yep both still low with CPU removed
> On Oct 9, 2013 8:55 PM, "Rodger Boots" <rlboots2@gmail.com> wrote:
>
>> Could be, remove the CPU and see if they are still low. That will tell
>> you if it is the CPU or the board.
>> On Oct 9, 2013 10:50 PM, "Joel Griffin Dodd" <griffindodd@gmail.com>
>> wrote:
>>
>>> Hey guys. Troubleshooting my non booting star wars board set.
>>>
>>> Checked all my voltages and clicks they look good.
>>> Firq, NMI and halt are all high
>>> However reset is permanently low as is Irq at the CPU.
>>>
>>> Any ideas where to go from here? Bad CPU?
>>>
>>> I'm following the star wars troubleshooting guide
>>>
>>> Joel
>>>
>>
---------------------------------------------------------------------------
** Unsubscribe, subscribe, or view the archives at http://www.vectorlist.org
** Please direct other questions, comments, or problems to chris@westnet.com
Received on Thu Oct 10 00:04:55 2013
This archive was generated by hypermail 2.1.8 : Thu Oct 10 2013 - 00:50:00 EDT