Re: Tempest Cabinet wall thickness??

I have a small amount of 1" T molding, so I know it does exist

Christopher Moore wrote:

> Hi All,
>
> Here's a trivial little question about cabinets.
>
> I picked up the Tempest cabinet that John Mehrtens
> posted on this list last week. The side pieces are
> wider than the T-moulding. I thought that since it
> was out in the weather that the particle board had
> just expanded.
>
> However, it is still uniform thickness. I didn't
> measure it but I'd say 1". My Irish made Tempest
> has a the same wall thickness as the particle board.
> I belive 3/4".
>
> After looking over the cabinet, I'm wondering if
> this Tempest used 1" particle board instead of 3/4"
> because it doesn't look all that water damaged except
> for on the bottom left side for an 1 inch or to.
>
> The damage really looks like they used 1" particle board
> with 3/4" T-moulding and the damage came from not
> having the T-moulding completely cover the edge.
>
> Does anybody else have or seen a Tempest with 1" particle
> board?
>
> Is T-moulding available in the 1" thickness?
>
> Thanks for reading.
> -Chris Moore
>
> P.S. After reading about the Bradley Trainer for years
> It's really cool to see one finally surface. It's kind
> of like finding the loch ness monster. :-)
>
> I hope Jess Askey posts a write up on it in his gamearchive site.
>
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
> Share information about yourself, create your own public profile at
> http://profiles.msn.com.
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Tue Oct 10 14:56:39 2000