Re: WG V2000 Question

You need to switch both pairs of wires (NOT WITH EACHOTHER; within each
pair, swap the wires). Think about it and you'll see why...

----- Original Message -----
From: "Jon Raiford" <raiford@mindspring.com>
To: <vectorlist@synthcom.com>
Sent: Friday, October 13, 2000 8:20 AM
Subject: Re: VECTOR: WG V2000 Question

> Thats odd. I thought they were all done at the game level. Anyway, you
need to figure out which axis needs to be swapped and swap the yoke wires
for that axis.
>
> Jon
>
> At 08:54 AM 10/13/2000 -0400, you wrote:
>
> >I have a Wells Gardner V2000 that was removed from a cockpit Omega Race.
I hooked it up in my Asteroids cabinet, but the picture is reversed to
accommodate the mirror effect of the OR cabinet. Any ideas on how to
correct it? It doesn't seem to be at the board level, because I have had it
plugged into three working Asteroids board sets, and they all were reversed
on this monitor, and not in my friends Asteroids cocktail.
> >
> >Thanks!
> >
> >-Paul
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Oct 13 22:12:14 2000