Re: Tech: Electrohome G05

Ok, check out Q701 and the surrounding circuit. The G05-801 manual says that this is the initial gain applied to the signal to correct for tube linearity. You can also test this in circuit by comparing voltages with the Y axis. Values should be almost identical.

Jon

At 04:40 PM 10/23/2000 +0000, you wrote:
>i have tried a working monitor and the
>game board is working 100%, no problems
>there either.
>
>
>>From: Jon Raiford <raiford@mindspring.com>
>>Reply-To: vectorlist@synthcom.com
>>To: vectorlist@synthcom.com
>>Subject: Re: VECTOR: Tech: Electrohome G05
>>Date: Mon, 23 Oct 2000 11:42:57 -0400
>>
>>Try swapping the x and y pins on the monitor connector (or try another known good monitor) to verify that this is a monitor problem. It sounds like it could be a problem with the game board.
>>
>>Jon
>>
>>At 03:18 PM 10/23/2000 +0000, you wrote:
>> >have a later model GO5 that i would like
>> >some help on, the monitor plays in the center
>> >of the screen approx. 1/4" wide, the full
>> >height of the screen, but does not go out
>> >towards the left or right any further than
>> >the 1/4" path, i have already installed a cap
>> >kit with transistors and resoldered all the
>> >head pins, with NO results, the HV unit is
>> >working, and the spot killer DOES NOT come
>> >on, and NO FUSES have been blown. Dont notice
>> >anything out of the ordinary, was wondering if
>> >someone on the list could help.
>>
>>---------------------------------------------------------------------------
>>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>>** message body to vectorlist-request@synthcom.com. Please direct other
>>** questions, comments, or problems to neil@synthcom.com.
>
>_________________________________________________________________________
>Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
>Share information about yourself, create your own public profile at http://profiles.msn.com.
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Mon Oct 23 14:06:33 2000