Re: Battlezone sound

The power tested correctly so I went down to the local parts shop and found
a bin of the TDA2002 ICs in the bargain section, so I snagged a handful.
Atari vectors are my favorite, so why not stock up?. Once I returned home I
replaced the 2 on the AR board and ta-da, full sound.

Thanks for the help Jon, it pointed me to the exact problem!

So - the shop that I went to had about 100 more of the TDA2002 ICs
available, what is a reasonable price for them? If they are a good enough
deal I'll go snag the rest of them and make them available to the list
members.

Gotta go play Battlezone,
-Dan

----- Original Message -----
From: "Jon Raiford" <raiford@mindspring.com>
To: <vectorlist@synthcom.com>
Sent: Saturday, November 11, 2000 11:08 AM
Subject: Re: VECTOR: Battlezone sound

> There are two general reasons for this - both involve the AR board. Its
> either the A (audio) or R (power regulator) :) If its a power issue
(check
> the voltage outputs on the AR), your best bet is to buy a rebuild kit from
> Bob Roberts. If its a problem with the audio, its most likely the
> amplifier (the IC mounted on the side of the heatsink with 5 pins). I
> forget the name of it, but Bob Roberts carries them as well.
>
> I know of at least one person who always rebuilds AR's whenever he buys
> Atari games. There are a lot of electrolytic caps on them that can easily
> dry up from a lot of use. I typically rape other AR boards for parts (I
> don't like to order parts for some reason)
>
> Jon
>
> At 09:17 AM 11/11/00 -0800, you wrote:
> >>>>
> Ok, I now have a working BZ caberet (see message thread from earlier this
> week). However, the sound amplifier is not working properly now. I can
> hear the game sounds from the speaker very faintly and there is a lot of
> static. The volume control only slightly increases the game sounds, from
> nothing to barely audible.
>
> I'm assuming there is something wrong with my amplifier PCB, how does one
> go about troubleshooting these?
>
> Thanks for being patient with my very basic questions :)
>
> -Dan
>
> <<<<
>
>
> --------------------------------------------------------------------------
-
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
>

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Sat Nov 11 21:35:59 2000