Re: Vector Monitor Inputs

this is for a wg6100!!!

signal inputs
"X" horz 16v p.p (+|-8V)
"y" vertical 12v p.p (+|-6V)
"z" beam drive 4v max brightness
        1v black level
input impedance
"x" = 2.5k, "y" = 2.8k "z" = 1k

writing rate
"x" .05" per microsecond
"y" .0375" per microsecond
(" is inch :)

ps i'm very willing to test and get go one of your cards on a wg6100 just send one
to me and i'll do the rest!!!! hehe..

>I was wondering if anyone knows for the few different types of Vector
>Monitors out there... what type of input are they using... Single
>Ended or Differential. I ask this because the Vector Frame ISA Card
>protype is being shipped from 4PCB today... and it is Differential
>Output?
>
>Our Card by default:
>X+ = +/- 2.5V
>X- = -/+ 2.5V
>Y+ = +/- 2.5V
>Y- = -/+ 2.5V
>etc.. for the color outputs as well
>
>If Most/All of the Vector Monitors are Single Ended
>X+ = +/- 5V
>Y+ = +/- 5V
>& Common Ground
>
>or is it 0-5V or similar...
>
>I can account for any of these types of signals in the Assembly phase to
>do this right on the board
>
>any info would be appreciated
>
>Thanks,
>
>Rob.
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to neil@synthcom.com.
>
>

__________________________________________________
Advertise with ZFREE - to find out more click below
http://www.zfree.co.nz/about-us/advert.html
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Thu Jul 12 02:51:12 2001