Re: Vector Monitor Inputs

thanks for the info... so I am assuming there is just a common gnd.

I think I have one of those monitors, I'd say hell yea to send you a card for
helping... but we have no money or card working yet :) all coming out of our pockets
right now

galaga@zfree.co.nz wrote:

> this is for a wg6100!!!
>
> signal inputs
> "X" horz 16v p.p (+|-8V)
> "y" vertical 12v p.p (+|-6V)
> "z" beam drive 4v max brightness
> 1v black level
> input impedance
> "x" = 2.5k, "y" = 2.8k "z" = 1k
>
> writing rate
> "x" .05" per microsecond
> "y" .0375" per microsecond
> (" is inch :)
>
> ps i'm very willing to test and get go one of your cards on a wg6100 just send one
> to me and i'll do the rest!!!! hehe..
>
> >I was wondering if anyone knows for the few different types of Vector
> >Monitors out there... what type of input are they using... Single
> >Ended or Differential. I ask this because the Vector Frame ISA Card
> >protype is being shipped from 4PCB today... and it is Differential
> >Output?
> >
> >Our Card by default:
> >X+ = +/- 2.5V
> >X- = -/+ 2.5V
> >Y+ = +/- 2.5V
> >Y- = -/+ 2.5V
> >etc.. for the color outputs as well
> >
> >If Most/All of the Vector Monitors are Single Ended
> >X+ = +/- 5V
> >Y+ = +/- 5V
> >& Common Ground
> >
> >or is it 0-5V or similar...
> >
> >I can account for any of these types of signals in the Assembly phase to
> >do this right on the board
> >
> >any info would be appreciated
> >
> >Thanks,
> >
> >Rob.
> >
> >---------------------------------------------------------------------------
> >** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> >** message body to vectorlist-request@synthcom.com. Please direct other
> >** questions, comments, or problems to neil@synthcom.com.
> >
> >
>
> __________________________________________________
> Advertise with ZFREE - to find out more click below
> http://www.zfree.co.nz/about-us/advert.html
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Thu Jul 12 19:39:34 2001