Curtis,
The drop slot coin door is an older (and much less common) Atari coin door.
The monitor you most likely have a WG 19V2000. Look here to verify.
For the Plexi on the SW CP, I would try a good glass store in your area. They
may be able to bend it for you too. If not, you could bend it by heating a rod
with a torch and holding the plexi over it to bend it.
The marquee is not supposed to be smoked plexi.......
Locks are readily available from Bob Robets or Happ Controls.
"Curtis H. Wilbar Jr." wrote:
> Sorry for yet another Q... the asteroids I got has a coin door like
> I haven't seen before... it has two circular openings rather than
> the standard two slot openings.... is this normal for certain
> productions of Asteroids.... I know my serial number is in the
> very very low 10000 range...
>
> -- Curt
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Apr 26 20:58:27 2002
This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:00 EDT