Re: Re[2]: 2N6259's

Where did you get the MJ15024s? Not at Digi-Key or a few of my regular
suppliers...

John :-#)#

At 05:30 PM 07/10/2002 -0400, Mark Jenison wrote:

>Well, chalk up another 8 hours of straight running on MJ15024 transistors.
>And I can still put my finger on them. I'm putting the monitor away now;
>I've seen enough to make my decision.
>
>----- Original Message -----
>From: "Mark Jenison" <jenison@enteract.com>
>To: <vectorlist@synthcom.com>
>Sent: Monday, October 07, 2002 10:06 AM
>Subject: Re: Re[2]: VECTOR: 2N6259's
>
>
> > ----- Original Message -----
> > From: "Mark Jenison" <jenison@enteract.com>
> > To: <vectorlist@synthcom.com>
> > Sent: Thursday, October 03, 2002 11:11 PM
> > Subject: Re: Re[2]: VECTOR: 2N6259's
> >
> > > Someone suggested trying the MJ15024 transistor, so I purchased 4 of
>them
> > > and will be trying them out this weekend. I forget the exact price, but
> > > they were cheap. Will report back the results on Monday.
> >
> > Thanks to Derek Bell for sending me a spare chassis that had a good custom
> > chip on it. I replaced it in my test monitor and it works perfectly
>again.
> >
> > So I installed 4 MJ15024 transistors in a spare heat sink/fan unit, and
> > dropped it into my test monitor this weekend. Has been running fine for
>10
> > hours; transistors are running just slightly cooler than the 2N6259s in
> > another game that I'm running at the same time (2N6259s too hot to keep
> > finger on; MJ15024s just bearable -- there's some accurate measurements
>for
> > ya ;-)).
> >
> > How much testing should be done before giving a "thumbs up" on a
>replacement
> > part?
> >
> > --
> > Mark Jenison
> >
> >
> >
> >
> > --------------------------------------------------------------------------
>-
> > ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
>the
> > ** message body to vectorlist-request@synthcom.com. Please direct other
> > ** questions, comments, or problems to vectorlist-owner@synthcom.com.
> >
>
>---------------------------------------------------------------------------
>** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
>** message body to vectorlist-request@synthcom.com. Please direct other
>** questions, comments, or problems to vectorlist-owner@synthcom.com.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Tue Oct 8 12:06:02 2002