Re: Asteroids rapair saga

From: <steve_at_coule.freeserve.co.uk>
Date: Mon May 19 2003 - 11:01:48 EDT

It's most likely a dead 2114 ram at E2. You don't get six beeps unless it's P4 that's dead - the beeps stop when the first bad ram is detected.

1 beep = D2
2 = E4
3 = M4
4 = R4
5 = N4
6 = P4

Steve

>
> From: "MyPearl" <mypearl@dds.nl>
> Date: Mon 19/May/2003 11:59 GMT
> To: <vectorlist@synthcom.com>
> Subject: VECTOR: Asteroids rapair saga
>
> Hello group,
>
> I've been working on my project Asteroids for a few weeks now, and I could
> use a little help with it now. :)
>
> The board (rev 4) was completely dead, watchdog resets were constantly
> happening. That was fixed by installing a new CPU and ROM at D/E1. To be
> safe, I replaced the 245 buffer as well.
>
> A tip in the 'Asteroids repair enceclopedia' suggested to disconnect the
> /DMAGO signal by desoldering LS43 at L6 and lifting pin 1.
>
> Now the board does run, no more watchdog resets. In test mode, I can see two
> beeps passing along on my scope (I have the board running at my bench off a
> single 5V power supply). Not the sequence of six beeps, as described in the
> manual.
>
> I don't really know where to look further, so any help would be GREATLY
> appreciated!
>
> Cheers,
>
> Mendel
>
>
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to vectorlist-owner@synthcom.com.
>
>

__________________________________________________________________________
Join Freeserve http://www.freeserve.com/time/

Winner of the 2003 Internet Service Providers' Association awards for Best Unmetered ISP and Best Consumer Application.

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to vectorlist-owner@synthcom.com.
Received on Mon May 19 08:02:07 2003

This archive was generated by hypermail 2.1.8 : Fri Aug 01 2003 - 00:34:31 EDT