Re: Fluke 9010A Input voltage

Hello Steve,

You are correct. Thanks to John Robertson I figured out there is a slide card for voltage selection behind the fuse panel. No need to drag the systems out of your garage ;-)

Thanks for your help!

Filip
  ----- Original Message -----
  From: Steve C
  To: 'Technical Tools Mail List'
  Sent: Monday, October 31, 2005 8:52 PM
  Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

  There *must* be something on the outside, I bought two 9010a's from the US and I certainly didn't open the case to change the voltage! My 9010a's are in the garage loft at the moment, and there's a car in it so I can't drag either out to check!

  Is there one of those rotate to voltage type things? Maybe it's the 9100a that has a plastic cover and plug to change the voltage?

  -----Original Message-----
  From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
  Sent: 31 October 2005 19:08
  To: Technical Tools Mail List
  Subject: Re: [Techtoolslist] Fluke 9010A Input voltage

  Steve,

  There is no panel nor switch on the back. However there is a note referring to the manual (orientation of the mains circuit board). Unfortunately I was not able to locate any information about this in the service manual. I was hoping someone had done this before and could tell me immediately what actions to perform.

  Best regards,

  Filip

    ----- Original Message -----

    From: Steve C

    To: 'Technical Tools Mail List'

    Sent: Monday, October 31, 2005 7:59 PM

    Subject: RE: [Techtoolslist] Fluke 9010A Input voltage

    Yes, there is a panel on the back that allows voltage selection - I can't remember how but it was easy.

    Steve

    -----Original Message-----
    From: techtoolslist-bounces@flippers.com [mailto:techtoolslist-bounces@flippers.com] On Behalf Of Filip Hautekeete
    Sent: 31 October 2005 13:27
    To: techtoolslist@flippers.com
    Subject: [Techtoolslist] Fluke 9010A Input voltage

    Hi all,

    Is there any easy way to switch the Fluke 9010A from VAC 120 (factory installed) to VAC 240 ?

    Best regards,

    Filip

----------------------------------------------------------------------------

    _______________________________________________
    Techtoolslist mailing list
    Techtoolslist@flippers.com
    http://seven.pairlist.net/mailman/listinfo/techtoolslist

------------------------------------------------------------------------------

  _______________________________________________
  Techtoolslist mailing list
  Techtoolslist@flippers.com
  http://seven.pairlist.net/mailman/listinfo/techtoolslist

_______________________________________________
Techtoolslist mailing list
Techtoolslist@flippers.com
http://seven.pairlist.net/mailman/listinfo/techtoolslist
Received on Mon Oct 31 15:51:57 2005