RE: G-05 parts question...

        I have, and they work (and fit) great. Actually, I always
wondered why everyone was talking about using RTV, etc, because with the
527A, at least, it fits into the original holder just fine (it is a little
bigger than the original diode, but it still fits.)

        Unfortunately for y'all, my source for these parts was my local
NTE distributor, and even he was sporadic. I'd just ask if he had
any every time I went in there, and every so often he would.

Joe

On Sat, 14 Oct 2000, Chris Loggans wrote:

> Has anyone ever seen or tried the NTE 527A as a replacement? I looked it up
> in my NTE catalog (1995'ish) and it appears that the packaging is round and
> closer to the size of the original H1812 than the SK7333. I don't know if
> these are available anymore since they are no longer listed on the NTE web
> site, but I was just curious if anyone has ever had a chance to try them.
>
> -Chris
>
>
> -----Original Message-----
> From: Gregg Woodcock
> To: vectorlist@synthcom.com
> Sent: 10/14/00 1:12 AM
> Subject: Re: VECTOR: G-05 parts question...
>
>
> ----- Original Message -----
> From: "Jon Raiford" <raiford@mindspring.com>
> To: <vectorlist@synthcom.com>
> Sent: Saturday, October 14, 2000 1:43 AM
> Subject: Re: VECTOR: G-05 parts question...
>
>
> > At 10:21 PM 10/13/2000, you wrote:
> > >> >H1812 -- that's what's on the original diode.
> > >
> > >These are hard to find (virtually impossible) but I have found that
> SK
> > >7333 work
> > >just find. I just did a repair last week with one.
> >
> >
> > Is that a same-size replacement? Or do you have to solder the diode
> in
> place?
>
> No, it has a square cross-section instead of a circle and is about 100%
> longer.
> Just solder it in and cover the tips with HV RTV Sillicone (red).
>
> ------------------------------------------------------------------------
> ---
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in
> the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
> ---------------------------------------------------------------------------
> ** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please direct other
> ** questions, comments, or problems to neil@synthcom.com.
>

------------------------------------------------------------------
Joseph J. Welser jwelser@ccwf.cc.utexas.edu
Design Engineer -- Crystal Semiconductor Corporation
Work: jwelser_at_crystal.cirrus.com http://www.crystal.com
P.O. Box 17847; Austin, TX 78760
------------------------------------------------------------------

---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Fri Oct 20 12:22:08 2000