RE: Slew Rates

For the WG 19K640x:

--------------
  4. WRITING DISTANCE VS. TIME:
       Measured maximum time durations per line segment @ -10% line.
       "X"...6.0us for 0.5" "Y"...6.0us for 0.5"
             8.0us for 1.0" 8.0us for 1.0"
            16.0us for 2.0" 21.0us for 2.0"
            30.0us for 4.0" 42.0us for 4.0"
            62.0us for 8.0" 94.0us for 8.0"
           110.0us for 14.5" 131.0us for 10.5"
--------------

Dave

> -----Original Message-----
> From: Jon Raiford [mailto:raiford@mindspring.com]
> Sent: Wednesday, October 25, 2000 1:31 PM
> To: vectorlist@synthcom.com
> Subject: VECTOR: Slew Rates
>
>
> I just felt like throwing together the slew rates that I
> could find for various vector monitors. How do these compare
> to each other? And I wonder how this would/could compare to
> that laser's spec.
>
> LAI XY Monitor: "2.3KHz at +/- 21V"
>
> G05-801/802 Monitor: "2300 Hz at +/- 25V"
>
> G05-802/805 Monitor: "Large signal slew rate for full
> deflection is approximately 150 usec"
>
> WG6100: '"X" amplifier = .05 inch per microsecond,
> "Y" amplifier = .0375 inch per microsecond.'
>
> Amplifone: ?? - Couldn't find anything in the manual.
>
> WG19V2000: "The small signal response of the amplifier is
> DC to approximately 2 MHz with the large signal being limited
> mainly by yoke inductance and available supply voltage to a
> maximum slew rate of approximately 120 usec. for full deflection."
>
> G08 Monitor: ?? - Couldn't find anything in the manual.
>
> Jon
>
> --------------------------------------------------------------
> -------------
> ** To UNSUBSCRIBE from vectorlist, send a message with
> "UNSUBSCRIBE" in the
> ** message body to vectorlist-request@synthcom.com. Please
> direct other
> ** questions, comments, or problems to neil@synthcom.com.
>
---------------------------------------------------------------------------
** To UNSUBSCRIBE from vectorlist, send a message with "UNSUBSCRIBE" in the
** message body to vectorlist-request@synthcom.com. Please direct other
** questions, comments, or problems to neil@synthcom.com.
Received on Wed Oct 25 13:54:01 2000